أنشئ حسابًا أو سجّل الدخول للانضمام إلى مجتمعك المهني.
A. Set the master-slave jumper to slave on the second drive
B. Use the IDE configuration software to set the new drive as slave
C. Verify that you define the new drive as D: in the CMOS setup
D. Verify that you attach the drive to the connector at the end of the ribbon cable
E. None of the above
A. Set the master-slave jumper to slave on the second drive .
Option (A) is the answer. Thanks.
IDE drives come with jumpers in place set to master. Move the jumper to the Slave position on the new drive.
Option A is a right answer
Master-Slave jumper sleave.................
Option A........................................