ابدأ بالتواصل مع الأشخاص وتبادل معارفك المهنية

أنشئ حسابًا أو سجّل الدخول للانضمام إلى مجتمعك المهني.

متابعة

During startup you heard 9 beep codes and there is no any display on your monitor,considering your power supply is good.What is the probable cause?

user-image
تم إضافة السؤال من قبل Rhoel M. Lambino , IT Support in-Charge , Safari Company Limited
تاريخ النشر: 2016/09/01
Premod Panaparampil Karunakaran
من قبل Premod Panaparampil Karunakaran , IT Manager/System Admin , IT MAnager/System Administrator

Display  Adapter has a problem. 

Rayes Ahmad
من قبل Rayes Ahmad , IT Specialist , Hcl Technologies

 

9 beep code basically indicate to ROM checksum error , or it can be faulty chip , must be replaced  

Akram Naeem
من قبل Akram Naeem , Technical Support , AMSI

ROM BIOS checksum failure error 

Syed Imran Ahmed
من قبل Syed Imran Ahmed , Technology Solution Consultant - Business Critical servers – HP Itanium blade /HP 9K servers , Hewlett Packard enterprise

The DIMMS / slot, needs to be checked 

Rommel Brutas
من قبل Rommel Brutas , Executive Secretary cum Operation Supervisor , Fagr Al Benaa Co. (FABCO)

Perhaps the memory card is not properly inserted to its slot.

مستخدم محذوف‎
من قبل مستخدم محذوف‎

Something is wrong on the mainboard that prevents it from starting up for sure. It can be a hard to detect issue like a high temperature within the case that prevents mainboard to function (wait for mainboard to cool down, then try again) or as simple as a card or memory that is not firmly placed in its slot. Some mainboards also make sound when their batteries are about to die.

 

 

 to see if they are placed firmly in their sockets is the physical check. 

Kazi Akhluck Hossain
من قبل Kazi Akhluck Hossain , IT Manager (Part Time) , MR Sourcing

Commonly RAM or RAM Slot of the Mather Board Problem.

المزيد من الأسئلة المماثلة