ابدأ بالتواصل مع الأشخاص وتبادل معارفك المهنية

أنشئ حسابًا أو سجّل الدخول للانضمام إلى مجتمعك المهني.

متابعة

In a piping system, how can you locate the position of support(Drag anchor support...etc)?

user-image
تم إضافة السؤال من قبل AbdulRahman Belhareth , Piping Engineer IV , Saudi Aramco
تاريخ النشر: 2017/04/16
مستخدم محذوف‎
من قبل مستخدم محذوف‎

At the beginning of the development of this engineering practice to determine the position of the supports were made complex resistance calculations between two supports with freedom degrees according with the nature of the piping system necessity, both for empty pipes, and for water-filled pipes. Over the time, the results were standardized according to nominal pipe size, wall thickness and the distance between the supports for empty pipes, and / or water-filled pipes for different groups and categories of materials (iron, steel, stainless steel and so on).

Nowadays we use different software’s but, let's not forget to remember the fact that you have to have knowledge of resistance calculations, material standards and a vast field experience otherwise, the result will be one of a cartoon for children’s.

 

Good luck!

Fadi ELHAJDAOUD
من قبل Fadi ELHAJDAOUD , Projects Controls Engineer – AWP / VDC , CCC

After reaching 90% design model stage , there are some special softwares  that analyse  the stress in the piping system and assign support types and their locations on the piping lines. After that Isometric drawing generation starts with the pipe supports allocated and tagged.

MITHILESH GIRI
من قبل MITHILESH GIRI , Project Engineer , Sitson India Pvt. Ltd

It is depends upon the Specification of pipe and routing of it and also Type of piping work like IBR or NIBR etc.

Jesus Jr Callos
من قبل Jesus Jr Callos , Piping Engineer , Mitsubishi Heavy Industries

To determine the position of the support, complex resistance and stress analysis according to the specifications of piping with or without filling. Standardizations will be carried out according to material, nominal size, wall thickness and distances between support.

Ibrahim Yunusa
من قبل Ibrahim Yunusa , Welding Engineer , Nigeria college of aviation technology Zaria

Ok is defence if pipe joint is tee joint or corner joint its position when Starting a welding to be adjustable to the anchor

Ramon Labrador
من قبل Ramon Labrador , Senior Materials Engineer (Civil) , WS Atkins & Partners (Overseas)

Supports on expansion joints and change in direction

ramesh puppala
من قبل ramesh puppala , Site Project Manager , M/s Finesco International Co.

Shall be determined by calculating stress analysis software.

MOHAMMED MUBASHIR RAYAMARAKKAR VEETTIL
من قبل MOHAMMED MUBASHIR RAYAMARAKKAR VEETTIL , Mechanical / Piping Engineer , contracting and trading

pipe support are select based on pipe size, flow rate, fluid characteristic, atmosphere, and equipment weight. 

المزيد من الأسئلة المماثلة