ابدأ بالتواصل مع الأشخاص وتبادل معارفك المهنية

أنشئ حسابًا أو سجّل الدخول للانضمام إلى مجتمعك المهني.

متابعة

If a resistance is connected in series with the primary of a transformer, what will be the probable effect

user-image
تم إضافة السؤال من قبل مستخدم محذوف‎
تاريخ النشر: 2013/05/24
Leonardo Banzali
من قبل Leonardo Banzali , Electrical Maintenance-trainer , Sadara Chemical Company

Only will cause a voltage drop to the primary voltage.

Bulbasa Ionel - Leon
من قبل Bulbasa Ionel - Leon , PLC Programmer , IPTE Sibiu

A resistance, used alone, will reduce the tension from that circuit.

However, in my country, the law says sometjing like this:"it is forbiden to reduce the voltage in a circuit by using a resistance !". Since the resistor will heat it self [P=R*I(^2)] it became a danger - a fire can occur.

Wish you the best! 

Muhammad Aamir Abdul Majeed
من قبل Muhammad Aamir Abdul Majeed , Plant Manager , Transfopower Industries

Why you  want to add resistance in series with the primary of a transformer? To me it is not advisable.

gamal eid
من قبل gamal eid , site Manager , NESMA

There is a voltage drop happen in primary voltage (V1) so the secondry transformer voltage (v2) wil be lower than its rate 

eg. if the transformer rate is from24 V to220 V 

24 volt will be say20 Volt after add resistance 

and the secondry will be185 V

Engr Qazi Waqar Ali
من قبل Engr Qazi Waqar Ali , Applied Engineering Teacher , Technical and Vocational Education & Training

if you connect a resistance in series with primary of a transformer it will limit the value of primary current and hence the secondary current will be increased.

Vinod Kumar Unnikrishnan
من قبل Vinod Kumar Unnikrishnan , Maintenance Superintendent , sinyar Property Management LLC

Decrease in secondary induced emf.

Abdul rauf
من قبل Abdul rauf , supervisor , Naizak Globel System

IF a resistance is connected in series with the primry of transfromer so transfarmer is work but no true

tamer mahmoud mohamed mohamed abd elgawad
من قبل tamer mahmoud mohamed mohamed abd elgawad , Senior MEP Project Manager , Voltas Limited - United Arab Emirates

It will decrease the primary current which leads to decrease the secondary current leading to decrease the secondary voltage by other words It will divid the total voltage applied into two voltage one on the series resistance and one on the primary winding and it's values depend on it's resistances any way the winding voltage now is less than the normal .
Transferring smaller value of voltage leads to smaller value in voltage on the secondary winding regardeless it's a step up or down transformer

مستخدم محذوف‎
من قبل مستخدم محذوف‎

Two things can happen in connecting a resistance in series with the transformer primary winding. adding a resistor crates voltage drop in it, reducing the primary voltage at the terminals. Hence secondary output will be less. 

Secondly the resistor gets heated up, hence it is not advisable to connect the same to reduce output voltage. Increasing primary resistance increase the inductive reactance, which reduce the magnetizing current, which leads to insufficient core magnetization.

Ernest Futar
من قبل Ernest Futar , pensioner , utility

It distorts the sinusoidal voltage of the transformes's sec winding

Mawloud Kalimat
من قبل Mawloud Kalimat , General Manager , H. Doctors Pharmaceuticals Industries Company

Decrease in secondary induced emf.

المزيد من الأسئلة المماثلة