A hydraulic filter press is set to compact at max 300 bar,but the system persistently registers different low pressures on subsequent cycles.Any help?

Theres no leakage detected so far.What might be the underlying problem

Question added by walter Kidaha kisiavuki , Mechanical Maintenance Supervisor , Gulf Fluor LLC
Date Posted: 2015/05/10

Upvote (0) Views (1) Followers (2) Answers (1) Report Question

Write an Answer
Register now or log in to answer.

by magdy abd al nour , HVAC Site manger , First United Co.

i think the if the filter can take more not less than the system pressure its good to use

Upvote (0)

Downvote Reply () Report

How can I solve this proxy problem ?
Top Answer: <p>the problem you have i think in the Group policy of your domain so everytime you change the sett ... See More

Answers (11)
What is the role of pressure differential switch in merv filters? is it requried interface with bms system or not?
Top Answer: It is because when the filter is full of dust then the pressure difference will be more so it will buzz a ... See More

Answers (1)
Exiting pipe line design pressure 20 bar. What should be the testing pressure?
Top Answer: Testing should be done with a safety factor of 1.5. That is, testing should be carried out at 30 bar. ... See More

Answers (2)
LNG process : is the compressor the only requirement for expansion from HIGH PRESSURE to medium pressure and finally to low pressure ? ( propane loop )
Top Answer: The refrigeration loop basically contains the following main components (assumed:2-stages refrigeration l ... See More

Answers (1)