Register now or log in to join your professional community.
CONCRETE DESIGN STUDY
A. Purpose
1) Check that the nominal composition of the concrete proposed by the Contractor enables
the specification to be met.
2) Check that the concrete specifications are still respected if the quality of the ingredients
reaches the specified limits or the probable limits of the ingredients used.
3) Check that the concrete specifications are still respected if the proportions of the
ingredients reach the specified limits or the probable limits resulting from the site
installation (the design limits may also be chosen so as to study several nominal
compositions simultaneously).
B. The design test will involve the following operations:
1) Three batches meeting the nominal formula.
2) Eight batches varying from the nominal formula as follows:
a) Two batches by modifying the proportions of aggregates (for example variation of the
ratio of the mass of coarse aggregates to that of finer aggregates by% in either
direction).
b) Two batches by altering the quantity of mixing water ( l/m³ more and less).
c) Two batches by altering the quantity of cement ( kg/m³ more and less).
d) If an additive or additives are used, two batches by altering the quantity or quantities
of additives (half and double the optimum quantities).
C. Measurements made for concrete classes A, B and C:
1) Each batch shall be the subject of the following measurements:
2) consistency;
3) density and air content within the fresh concrete;
4) density of concrete at days;
5) compressive strength at7 days on three samples;
6) compressive strength at days on three samples and static modulus of elasticity and
Poisson's ratio (in addition to ASTM C strains shall be measured for stresses of3,5,7,
9, MPa).
7) The components shall be subject to the control measurements specified elsewhere.
8) Also to be noted are the following factors:
a) Temperature of the components and of the concrete during the tests.
b) Aspect of the fresh concrete during performance of the consistency test and of the
preparation of the specimens.
c) Aspect of breakage during the mechanical tests.
MR HATEM LABIB , answerd all correct
Do you need help in adding the right keywords to your CV? Let our CV writing experts help you.