What is the command syntax to disable POE on a switch port?

Question added by Micheal Egereugwu , IT TECHNICAL SUPPORT ENGINEER , AFRI-HUB ICT CENTER
Date Posted: 2017/07/28

Upvote (0) Views (3) Followers (1) Answers (1) Report Question

Write an Answer
Register now or log in to answer.

by Micheal Egereugwu , IT TECHNICAL SUPPORT ENGINEER , AFRI-HUB ICT CENTER

sw(config-if)#power inline never

verification:sw# shpower inline {type mod/no}

Upvote (0)

Downvote Reply () Report

What is the command syntax to make a switch attempt to become the primary root bridge?
Top Answer: SW(config)# spanning-tree vlan vlan-no root{primary/secondary}*{diameter diameter} See More

Answers (1)
What is a switched virtual interface SVI as related to MLS and what is the command syntax to configure this?
Top Answer: SVI is a logical interface that is assigned a network layer 3 address and represents an entire vlan to co ... See More

Answers (1)
What is qos. what is the command syntax to configure a trust boundary between an ip phone and a switch?
Top Answer: qos is the overall method used in a network to protect and prioritize time-critical or important traffic. ... See More

Answers (1)
How much impact will bring usage of PoE switch instead of injector for scenario of 30 devices?
Top Answer: It will be good using two port PoE switches for devices( AP's on one switch and the remaining on the sec ... See More

Answers (1)