Bayt.com

Start networking and exchanging professional insights

Register now or log in to join your professional community.

Follow

Which of the following commands enables the IPv6 protocol on a router?

A. Router(config)#ipv6 unicast-routing B. Router(config)#ipv6 enable C. Router(config)#enable ipv6 D. Router(config)#ipv6 E. Router(config)#router ipv6

Networking Concepts CCNA
user-image
Question added by TARIQ MUHAMMAD ISMAIL MEMON , IT Team Leader , Saudi National Bank (Microland)
Date Posted: 2013/12/05
Upvote (1) Views (20) Followers (6) Answers (17) Report Question
Write an Answer
Register now or log in to answer.
Ahamed Ameen
by Ahamed Ameen , IT Infrastructure Manager , Abana Enterprises Group of Company

to enable the IPv6 in  a router you need to enter "Router(config)#ipv6 unicast-routing" in global configuration mode.

Deleted user
by Deleted user

Router(config)#ipv6 unicast-routing

JAYENDRA PARMAR
by JAYENDRA PARMAR , Support Engineers , Dunia finance LLC

Router(config)# ipv6 unicast-routing... This command is using very first time when configuring IPV6 protocol on a router.. 

Noman Abdul Hadi Memon
by Noman Abdul Hadi Memon , IT Specialist , Wael Fouad Jamjoom Co. For Umrah

A Is The Correct Answer Brother Tariq ..

Mohammad Zahirul Islam
by Mohammad Zahirul Islam , IT Manager , Windy Group

A is the correct ans.

Muhammad Yuseef
by Muhammad Yuseef , IT Manager , Master Point Trading

 

A is the correct answer 

 

Router(config)#ipv6 unicast-routing

MOHD YASIR
by MOHD YASIR , Solution Architect Support , Tech Mahindra ltd

A. Router(config)#ipv6 unicast-routing this commond is change the mode of router ipv4 to ipv6

Syed Javed
by Syed Javed , it consultant , Infosys

To use feature of IPv6, you need to enable it by IPv6 unicast-routing command in global config mode.

 

 

RAVI TEJA K.V.

By default, IPv6 traffic-forwarding is disabled on a Cisco router. It must to be activated between interfaces by using the global configuration command  - ipv6 unicast-routing . The global configuration command must be used in both Stateful (DHCPv6) and Stateless auto configuration.    There are two basic steps used to activate IPv6 on a Cisco router:  i.First, you must activate IPv6 traffic-forwarding on the router, and  ii.then you must configure each interface that requires IPv6.

 

See More Answers
Write Your Answer
More Questions Like This