Trending Gigabit Ethernet Discussions

What are 5 reasons why OSPF is not connected to a gigabit line? ‎

5 reasons why OSPF is not connected t a gigabit line ?‎

What is the command syntatx to enable ether channel using etherchannel negotiation protocol pagp.ethernet load balancing source and destination port?‎

 

Answer added by  Fahad Wasim, Network Support Engr. & CISCO Instructor, Sir Syed University of Engineering & Technology
7 years ago

Gigabit line is not an issue. Following are the reasons due to which OSPF does not perform adjancies: 1. Area Mismatch 2. Directly connected Network not advertised. 3. He ... See More

 

Answer added by  Micheal Egereugwu, IT TECHNICAL SUPPORT ENGINEER, AFRI-HUB ICT CENTER
7 years ago

sw(config)#port=channel load=balance src-dst-port sw(config)#int range type mod/no sw(config-if)#channel-protocol pagp sw(config-if)#channel-group 1 mode desirable non-si ... See More