For any load, what happen if we use the cable rating above its normal rating?

Question ajoutée par Sudhakar Nandigamu PMP , Project Manager/Sr.Electrical Engineer , MTC Qatar
Date de publication: 2014/07/07

Apprécier (1) Vues (4) Suiveurs (2) Réponses (1) Report Question

Ajoutez Une Réponse
Inscrivez-vous ou connectez-vous pour répondre.

par Sudhakar Nandigamu PMP , Project Manager/Sr.Electrical Engineer , MTC Qatar

nothing will happen to the load, only the cost increase

Apprécier (1)

Déprécier Réponses () Rapport

Offres d'Emploi Ingénieur Offres d'Emploi Vendeur Offres d'Emploi Comptable Offres d'Emploi Informaticien Offres d'Emploi Technicien

Does sun light affect the Cable rating ?
Top Answer: It is a practice to cover the cable trays, in case of direct exposure to sun rays.More than the temperatu ... Voir Plus

Réponses (4)
What is the power factor of a 3 phase induction motor operating at no load and connected to rated voltage?
Top Answer: The power factor in no-load condition ranges from 0.1 to 0.3. As the motor is run on no-load the major pa ... Voir Plus

Réponses (7)
Why using Copper Bus bar is better than using cables in high rise building ?
Top Answer: 1. LOW COST 2. EASY FOR MAINTEANCE 3.AVOIDING USAGE OF CABLE TRAYS 4.INSTALLATION REQUIRED ONLY LESS SPAC ... Voir Plus

Réponses (1)
How can I connect my router to other connected dsl router that make my router just as an access point by using cable, and in best cases by wireless?
Top Answer: <p>Configure your router to "Repeater" mode</p> Voir Plus

Réponses (1)