Step1:
Connect a computer to the access point.
Step2:
Assign a static IP address on the computer. For instructions, click here.
NOTE: To assign a static IP address on a wired Mac, click here.
Step3:
Open the access point’s web-based setup page. For instructions, click here.
NOTE: If you are using Mac to access the access point’s web-based setup page, click here.
Step4:
When the access point’s web-based setup page opens, take note of the Wireless MAC Address.
NOTE: The Wireless MAC Address you took note of will be entered on the WAP54G set as wireless repeater.
Step5:
After obtaining the wireless MAC address of the access point, configure the other WAP54G as a wireless bridge. For instructions, follow the steps below.
Setting-Up Wireless Bridge Mode on the WAP54G
Step1:
Connect a computer to the access point you want to configure as a wireless bridge.
Step2:
Assign a static IP address on the computer. For instructions, click here.
NOTE: To assign a static IP address on a wired Mac, click here.
Step3:
Open the access point’s web-based setup page. For instructions, click here.
NOTE: If you are using Mac to access the access point’s web-based setup page, click here.
Step4:
When the access point’s web-based setup page opens, click AP Mode.
NOTE: The access point’s web-based setup page may differ depending on the access point’s version number.
Step5:
Select Wireless Bridge and type the remote access point’s MAC address that you took note of earlier.
NOTE: Remove the colons (:) when typing the MAC address on the Remote Access Point’s LAN MAC Address field.
Step6:
Click .
Changing the LAN IP Address of the Wireless Bridge
After configuring the access point as a wireless bridge, change its LAN IP address to avoid IP address conflict.
you also can check this link to see the configurations by photos
http://kb.linksys.com/Linksys/ukp.aspx?pid=80&vw=1&articleid=4194
