Inscrivez-vous ou connectez-vous pour rejoindre votre communauté professionnelle.
- Oil trap exist to avoid oil escape from compressor to the other parts of refrigerant cycle
- that causes compressor damage and low Efficiency in refrigeration cycle
Oil traps are used when the pipe length is long; upto300 ft where as without one will take upto150 ft. P trap is given after every10 ft of vertical height.
Oil separator minimizes the amount of oil circulating in the cooling system. Oil to coat the inside of each cycle of the cooling components, through which it passes. This reduces the heat transfer efficiency and capacity of the evaporator and condensor. This is one of the reasons for separation as much oil as possible with the refrigerant before sending it to the system. Another reason is to slow down the accumulation of oil in those places where it is difficult to return the oil. This consideration is particularly important where the refrigerant is not mixed. The refrigerant does not dissolve in oil and oil is not soluble in refrigerant.
Oil Traps are used as a medium to enhance oil return mechanism.When refrigerant is released from the compressor at high pressure , the compressor oil is also pumped along with the refrigerant.This may cause poor heat tranfer rate as oil foms a coating on evaporater coil.This also reduces the compressor efficiency & life due to improper wear & tear occuring due to the lack of oil in compressor.
I agree with Muhammad Sharif answer .