Inscrivez-vous ou connectez-vous pour rejoindre votre communauté professionnelle.
..............................Thanks............................
You can assume the width and determine the depth.
controlling that by the loads, moments and forces which apply on joints.
How to determine the width of each type of joints in structures and buildings.
Building's structures are divided into two parts, the calculation of the structure depends on engineers. with buildings structure is good building automatically strong if the building structure no good any building collapse in few days. So, that's way the building structure very important.
Thanks with best regards,
Joint
joints should be calculated by structural engineer and approved in writing before constructing
is a mid separation design to relieve stress on building materials caused by building movement-induced by thermal expansion and contraction caused by temperature changes, sway caused by wind pressure, seismic events.
It depends on the loads the structure will carry.
Due to the low tensile capacity of concrete, some cracking in reinforced concrete is unavoidable. Contraction joints provide a weakened plane for cracks to form. Through the use of architectural details, these jOints can be located so that cracks will occur in less conspicuous locations within a building and possibly be eliminated from view. Expansion joints allow thermally induced movements to occur with a minimum build-up of stress. The greater the spacing between jOints, the greater the stresses. Typically, these jOints isolate a frame into a series I , 3 of segments with enough joint width to allow the building to expand with increasing temperature. By isolating the segments, expansion joints also provide relief from cracking due to contraction, and therefore act in a dual role.
There are Six main types of joints;
it depends on the structure situation after declaring the analysis of joint place in building or any structure we decide that it is a construction joint or a expansion joint than we decide the filling material for that joint place to fill it up.