Communiquez avec les autres et partagez vos connaissances professionnelles

Inscrivez-vous ou connectez-vous pour rejoindre votre communauté professionnelle.

Suivre

The drainage pipes from upper floors and that from ground floor is not connected together. why ?

user-image
Question ajoutée par mohamedi kassim hassan kaila , Mechanical Engineer -Plumbing and Hvac designer , Mes Engineering Consultancy Ltd
Date de publication: 2015/07/10
Sherif Mohammed Ibrahim
par Sherif Mohammed Ibrahim , Senior Mechanical Technical engineer , Al-Latifia Trading & Contracting Company

- Maintenance ( at least one floor will work)

- Avoid the effect of hydraulic jump.

Ismael Hamad
par Ismael Hamad , Trainer , ANTONOIL DMCC , Lukoil project, WQ2

 The PCM is the Power-train Control Module. It's the computer that pretty much runs the whole show and is very expensive to replace. The P0320 code suggest there is a problem with the Crankshaft Position Sensor (CPS). It can be tested in the vehicle using an OHM meter. With the engine hot and the connector removed from the CPS, reading across terminals A and B on the CPS you should have200 +/-75 OHMs. Any more or less and it needs to be replaced. The P0463 code suggest there could be a short to voltage on the lead between the PCM and the fuel gauge sending unit. Does the fuel gauge appear to be working correctly? If not this one might tough to find as there is a lot of wire between the fuel tank and the PC.

 

 Hope this helps U out.

magdy abd al nour
par magdy abd al nour , HVAC Site manger , First United Co.

passive cooling....new cooling Technic....Thermal Energy Storage (TES) is the temporary storage of high or low

temperature energy for later use. It bridges the gap between energy

requirement and energy use. A thermal storage application may involve a24

hour or alternatively a weekly or seasonal storage cycle depending on the

system design requirements. Whilst the output is always thermal, the input

energy may be either thermal or electrical.  

More Questions Like This