Communiquez avec les autres et partagez vos connaissances professionnelles

Inscrivez-vous ou connectez-vous pour rejoindre votre communauté professionnelle.

Suivre

What is the meaning of NO, NC and COM on the panel boards?

user-image
Question ajoutée par Ahmad Melhem , Low Current and KNX Engineer , Modern Times Technical Systems -MTTS Co
Date de publication: 2016/02/11
Jereme Dela Torre
par Jereme Dela Torre , Service Engineer , Honeywell Middle East Ltd.

NO - Normally Open, NC - Normally Close, Com - Common

Mohammed Khamis Alhajj Abdullah
par Mohammed Khamis Alhajj Abdullah , IT Manager , Matrix for Computer Sciences

No = Normal open , it's mean magnatic locK normal open

NC = Normal clos ,it's mean magnatic lock normal close

COM = Comman , it's mean ground connection

Marshal Anto Vincent
par Marshal Anto Vincent , SITE ENGINEER , NAFFCO

NC - NORMALLY CLOSED

NO - NORMALLY OPENED

COMM - COMMON

Shijoy Kurian George
par Shijoy Kurian George , elv project engineer , Radiant Plus Installation and Maintanance LLC

NC- normally close NO- Normally open C- Common

NO or NC connections are given according to the requirement of end user.

If the system which we are connecting the relay module function normally on closed circuit connection and stops when the circuit is open we use NC connection. If there is any trigger to relay module the connection become closed and the system shut down.

 

Joseph Solyman
par Joseph Solyman , Installation and maintenance Engineer , Chip International

Will control your relay output throw it

NO: Normally open it means the circuit is open until you activate the relay to close it for a specified time then it will back to Normally Open.

NC: Normally Close it means the circuit is close until you activate the relay to open it fro a specified time then it will back to Normally Close.  

COM: Common is used in both situation NO,NC

Utilisateur supprimé
par Utilisateur supprimé

NO - Normally open (In this case the device is is normally open condition when it is in idle state. and as soon as there is trigger. The circuit closes and and intrusion signal is sent.) This technique cannot handle for cable cut situation. 

NC - Normally Closed (In this case the device is is normally closed condition when it is in idle state. and as soon as there is trigger. The circuit opens and and intrusion signal is sent.). This technique is useful for the situations where the system need alert for cable cut or broken.

 

Com: Common and it used in both the above mentioned situation. because there is normally one common for for 2-4 zones. and each zone is assigned to separate device. 

More Questions Like This