Register now or log in to join your professional community.
the main reason it should not be interferiance with High voltage transmision line if the wireless communication have been used
Not familiar with these technical issues
the main reason it should not be interferiance with High voltage transmision line if the wireless communication have been used
or if we lost power supply from one side RTU side or PLC/DCS
finally we have more reason to lose comunication between them .
there is no main reason. if you have comminucation failure 1. the installation EMC values are high. 2.new hardware downlaod with new firmware.3 cable fault.
1. Direct interface means physical connection may cause problem.
2. Hardware problem may occur.
I would like to know your answer for the question, because I’m beginner in this field.
