What is the command syntax to disable POE on a switch port?

Question ajoutée par Micheal Egereugwu , IT TECHNICAL SUPPORT ENGINEER , AFRI-HUB ICT CENTER
Date de publication: 2017/07/28

Apprécier (0) Vues (3) Suiveurs (1) Réponses (1) Report Question

Ajoutez Une Réponse
Inscrivez-vous ou connectez-vous pour répondre.

par Micheal Egereugwu , IT TECHNICAL SUPPORT ENGINEER , AFRI-HUB ICT CENTER

sw(config-if)#power inline never

verification:sw# shpower inline {type mod/no}

Apprécier (0)

Déprécier Réponses () Rapport

Offres d'Emploi Ingénieur Offres d'Emploi Vendeur Offres d'Emploi Comptable Offres d'Emploi Informaticien Offres d'Emploi Technicien

What is the command syntax to make a switch attempt to become the primary root bridge?
Top Answer: SW(config)# spanning-tree vlan vlan-no root{primary/secondary}*{diameter diameter} Voir Plus

Réponses (1)
What is a switched virtual interface SVI as related to MLS and what is the command syntax to configure this?
Top Answer: SVI is a logical interface that is assigned a network layer 3 address and represents an entire vlan to co ... Voir Plus

Réponses (1)
What is qos. what is the command syntax to configure a trust boundary between an ip phone and a switch?
Top Answer: qos is the overall method used in a network to protect and prioritize time-critical or important traffic. ... Voir Plus

Réponses (1)
How much impact will bring usage of PoE switch instead of injector for scenario of 30 devices?
Top Answer: It will be good using two port PoE switches for devices( AP's on one switch and the remaining on the sec ... Voir Plus

Réponses (1)